Systemic Oxygenation
One of the fundamental goals of critical care management is to promote tissue oxygenation, yet it is not possible to monitor tissue oxygen levels in a clinical setting. This chapter describes the measures of “systemic” oxygenation that are available, and how they can be used to evaluate tissue oxygenation.
I. Measures of Systemic Oxygenation
A. Oxygen Content of Blood
The concentration of O2 in blood (called the O2 content) is the summed contribution of the O2 that is bound to hemoglobin (Hb) and the O2 that is dissolved in plasma.
1. Hemoglobin-Bound O2
The concentration of hemoglobin-bound O2 (HbO2) is determined as follows (1):
where Hb is the hemoglobin concentration in g/dL (grams per 100 mL), 1.34 is the O2 binding capacity of hemoglobin (mL/g), and SO2 is the O2 saturation of Hb, expressed as a ratio (HbO2/Total Hb).
Equation 6.1 states that, when Hb is fully saturated with oxygen (SO2 = 1), each gram of Hb binds 1.34 mL O2.
2. Dissolved O2
The concentration of dissolved O2 in plasma is determined as follows (2):
where PO2 is the partial pressure of O2 in blood (in mm Hg), and 0.003 is the solubility coefficient of O2 in plasma (mL/dL/mm Hg) at normal body temperature.
Equation 6.2 states that, at normal body temperature (37°C), each 1 mm Hg increment in PO2 will increase the concentration of dissolved O2 by 0.003 mL/dL (or 0.03 mL/L) (2). This highlights the poor solubility of oxygen in plasma (which is why hemoglobin is needed as a carrier molecule).
3. Total O2 Content
The total O2 content in blood (mL/dL) is determined by combining Equations 6.1 and 6.2:
Table 6.1 shows the normal concentrations of O2 (bound, dissolved, and total O2) in arterial and venous blood. Note that the contribution of dissolved O2 is very small; as a result, the O2 content of blood is considered equivalent to the Hb-bound fraction.
B. Oxygen Delivery
The rate of O2 transport in arterial blood, also known as oxygen delivery (DO2), is a function of the cardiac output (CO) and the O2 content of arterial blood (CaO2) (3).
(The multiplier of 10 is used to convert the CaO2 from mL/dL to mL/L.) If the CaO2 is broken down into its components, Equation 6.5 can be rewritten as:
Note: The SaO2 is monitored continuously with pulse oximeters, and the cardiac output can be measured with a pulmonary artery catheter (described in pages 88–91), or it can be measured noninvasively using techniques described in Reference 4.
Table 6.1 Normal Measures of Blood Oxygenation | |||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
The normal range of values for DO2 are shown in Table 6.2. Note that the DO2 (and VO2) are expressed in ab-solute and size-adjusted terms; the body size adjustment is based on body surface area in square meters (m2).
Table 6.2 Measures of Systemic Oxygen Balance | ||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
C. Oxygen Consumption
The rate of O2 uptake into tissues is equivalent to the oxygen consumption (VO2) because O2 is not stored in tissues There are two methods for determining the VO2.
1. Calculated VO2
The VO2 can be calculated as the product of the cardiac output (CO) and the difference between arterial and venous O2 contents (CaO2 – CvO2).
(The multiplier of 10 is explained for the DO2.) The CaO2 and CvO2 share a common term (1.34 * Hb), so Equation 6.7 can be rewritten as:
Note: Three of the four measurements used to calculate the VO2 are also used to calculate the DO2. The one ad-ditional measurement is the SvO2, which is described later in the chapter.
The normal range of values for VO2 is shown in Table 6.2. Note that the VO2 is much smaller than the DO2; the significance of this discrepancy is described later.
2. Calculated vs. Whole Body VO2
3. Measured VO2
The whole body VO2 can be measured with an O2 analyzer that measures the fractional concentration of O2 in inhaled and exhaled gas. The VO2 is then derived as follows: