Chapter 43 Renal Replacement Therapy and Rhabdomyolysis
Renal Replacement Therapy
1 What are the indications for renal replacement therapy (RRT)?
Indications can be grouped by using the AEIOU mnemonic:
A: (Metabolic) Acidosis refractory to bicarbonate administration.
E: Electrolyte imbalances, of which hyperkalemia is the most life threatening.
I: Ingestions. Some drugs and toxins (and their toxic metabolites) can be cleared with dialysis, including aspirin, lithium, methanol, or ethylene glycol.
O: Overload. Ultrafiltration with dialysis can relieve hypoxemia resulting from volume overload, which may be particularly problematic in the setting of oliguria or anuria.
U: Uremia. Symptoms and signs of uremia can range from mild (anorexia, nausea, pruritus) to severe (encephalopathy, asterixis, pericarditis); patients may also have clinical platelet dysfunction (bleeding) due to uremia.
2 List the different modes of RRT
Intermittent renal replacement therapies:
Continuous renal replacement therapies (CRRT):
6 Define hemofiltration, hemodialysis, and hemodiafiltration
Hemofiltration: Plasma is forced from the blood space into the effluent via the application of pressure across a highly permeable membrane. This results in convective clearance of small and middle-sized molecules through the physical property of solvent drag. This modality does not significantly change the concentration of serum electrolytes and waste products unless a replacement fluid is infused into the blood, effectively diluting out those solutes the physician wishes to remove (e.g., urea nitrogen and potassium) and increasing the concentration of those solutes in which the patient might be deficient (e.g., bicarbonate in a patient with acidemia).
Hemodialysis: Blood flows on one side of a semipermeable membrane, and the dialysate, which contains various electrolytes and glucose, flows along the other side, usually in the opposite (countercurrent) direction. A concentration gradient drives electrolytes and water-soluble waste products from the plasma compartment into the dialysate. The dialysis machine generates a pressure across the membrane to drive plasma water from the blood side to the dialysate side. Dialysis results in diffusive clearance, preferentially of small molecules.
Hemodiafiltration: This technique makes simultaneous use of hemofiltration and hemodialysis, resulting in both diffusive and convective clearance.
7 List the basic components of a prescription for IHD and for CRRT
Dialysis access: Arteriovenous fistula, arteriovenous graft, tunneled dialysis catheter, or temporary dialysis catheter
Treatment duration: For most patients with end-stage renal disease, this ranges between 3 and 4 hours. When a patient with acute renal failure or acute kidney injury (AKI) starts hemodialysis, initial sessions may be as short as 1 to 1.5 hours to decrease the risk of dialysis disequilibrium syndrome.
Filter size and type: Biocompatible dialysis membranes are now routinely used.
Blood flow rate: Blood flow rates of up to 400 to 450 mL/min can be achieved with an arteriovenous fistula or graft and up to 350 mL/min with a tunneled or temporary catheter. Generally, the faster the flow, the more efficient the dialysis.
Dialysate flow rate: Typical flow rates range from 500 mL/min to 800 mL/min.
Dialysate bath: Concentrations of potassium, sodium, calcium, and bicarbonate can be customized on the basis of the patient’s laboratory studies.
Ultrafiltration goal: This is the amount of fluid to be removed from the patient over the course of the session; determined by clinical assessment of the patient’s volume status.
Anticoagulation: Clotting within the dialysis circuit can result in significant blood loss; heparin is typically used unless the patient has a contraindication.
As in IHD, the prescription includes dialysis access, filter size and type, hourly fluid balance, and anticoagulation. An alternative to heparin anticoagulation often used with CRRT is regional citrate anticoagulation, in which citrate is administered to chelate calcium, a critical cofactor in the clotting cascade. Arteriovenous fistular and grafts are not used for CART.
Blood flow rates are typically slower than in intermittent dialysis (150-200 mL/min).
Mode of therapy: CVVH, CVVHD, or CVVHDF
Dialysate or replacement fluid: The specific fluid is based on the metabolic parameters of the patient, including the patient’s acid-base status and serum potassium concentration.
Dialysate or replacement fluid flow rate: Dosing is weight based and is typically prescribed at a dose ranging from 20 mL/kg/hr to 35 mL/kg/hr, based on the patient’s weight. Studies have shown no mortality difference between patients with renal replacement therapy administered at these two rates.
9 What are nutrition considerations for patients with AKI receiving RRT?
Amino acids are lost in both IHD and CRRT. Critically ill patients with AKI are often highly catabolic; many patients receiving CRRT will require at least 1.5 to 2 g/kg/day of protein or amino acids.